On 11 mar, 16:24, Mike Romain <roma...@[EMAIL PROTECTED]
> wrote:
> nrs wrote:
> > On 11 mar, 15:35, Mike Romain <roma...@[EMAIL PROTECTED]
> wrote:
> >> nrs wrote:
> >>> I recently had a starter rebuilt and now that it is installed, it
does=
> >>> not work very well. =A0It did not have any ****ms originally and it
was=
> >>> re-installed the same way. Sometimes it does not engage the flywheel
> >>> and when it does, it makes rumbling sounds. =A0Also, it makes a
scrapi=
ng
> >>> sound sometimes, both when it fails to engage and sometimes when it
> >>> does engage. =A0What could cause it to make scraping sounds?
=A0Thanks=
in
> >>> advance.
> >> That sounds like the bu****ng in the nose didn't get replaced or you
wer=
e
> >> too late and your flywheel ring gear is ground down...
>
> >> You need to pull the starter to see if it's the bu****ng or gear.
>
> >> A bad connection on the main cables going to the starter can also not
> >> pass enough power to kick it into the flywheel ring gear.
>
> >> Mike
> >> 86/00 CJ7 Laredo, 33x9.5 BFG Muds, 'glass nose to tail in '00
> >> 'New' frame in the works for '08. =A0Some Canadian Bush Trip and
Build
> >> Photos:http://mikeromainjeeptrips.shutterfly.com
>
> > The flywheel is fine. =A0The starter failed by not turning and up
until
> > then it worked perfectly so there was no chance to mess it up. =A0The
> > nose bu****ng sounds dead on because I noticed it was not replaced,
> > figured they found it was in spec and they didn't see the need to
> > change it. =A0That just might be the problem. =A0Thanks a lot.
>
> Just so you know, when the nose bu****ng went out on my 'under warranty'
> starter, it took less than a week to kill the ring gear. =A0I let it go
> until the weekend kind of idea on a daily driver. =A0The engine pull for
> the new ring gear wasn't under warranty.... (mine is easier to pull the
> engine on)
>
> Mike- Ocultar texto de la cita -
>
> - Mostrar texto de la cita -
Thanks for the heads up. I think I'll take the Jeep to the shop
tomorrow and let them worry about it, just as long as they don't want
to charge more for work on the starter itself.
|
