by "greenxj" <u43105@[EMAIL PROTECTED]
>
Apr 23, 2008 at 03:56 AM
I did as much reading as I could, but unfortunately it doesn't have
anything
on the 232... so I am really kind of in the same spot. I do thank you VERY
much for your input. As I said, any and all is welcome.
My thinking was kind of this way. If the AW4 tranny is in both, than
wouldn't
it make sense that each t-case would bolt in relatively the same way?
Disregarding drive shafts and all... wouldn't that kind of make sense?
Greg wrote:
>You could try looking here,
>http://www.novak-adapt.com/knowledge/transfer_case_gateway.htm
may tell
you
>wat each will mate up to.
>
>> Hey guys,
>> I am in almost desperate need of some ideas here. I have a 1999 Jeep
>[quoted text clipped - 13 lines]
>>
>> Thanks again
