Thanks Mike.
I'm going after the ground. As most electrical problems are almost
always a dodgy ground.
BTW, both the log beam and high beam filaments are good in both the
bulbs.
Cheers
Ry'
On Wed, 30 Apr 2008 15:57:52 -0400, Mike Romain <romainm@[EMAIL PROTECTED]
>
wrote:
>It 'is' the highbeam bulb by the by... The Canadian daytime running
>lights use highbeams on half power as far as I know.
>
>So if you are testing the low beam bulb, it will be fine..... :-)
>
>If the high beam bulb is indeed good, then I would trace the ground tag
>for it, likely a black wire going to a screw the grill or fender at the
>end of the harness piece.
>
>The relay should run both of them, but I don't have a wiring diagram to
>verify that.
>
>Mike
>
>Socks wrote:
>> Both bulbs work. I tested them with a bench top 12 volt power supply.
>> Even took the bulb from the drivers side and plugged it in on the
>> passengers side and vice versa.
>> The bulbs are brand new Hella.
>> I just tried with another fresh unopened pack of Bosch/Osram bulbs
>> this morning. Same thing happens-Drivers side Day time running lights
>> and low beam does not work.
>> As yes Mike, I am aware that the Day time running lights and low beam
>> are one of the same circuits.
>> That's why I am wondering if the low beam (Although I typed out high
>> beam) relay is at fault.
>>
>> Thanks guys
>>
>> Ryan
>>
>>
>> On Tue, 29 Apr 2008 09:22:11 -0400, Mike Romain <romainm@[EMAIL PROTECTED]
>
>> wrote:
>>
>>> That indicates you have a burned out high beam filament.
>>>
>>> The daytime lights are the high beam on half power.
>>>
>>> Mike
>>> 86/00 CJ7 Laredo, 33x9.5 BFG Muds, 'glass nose to tail in '00
>>> 'New' frame in the works for '08. Some Canadian Bush Trip and Build
>>> Photos: http://mikeromainjeeptrips.shutterfly.com
>>>
>>>
>>> Socks wrote:
>>>> Good day,
>>>>
>>>> My wife and I own a 2004 Liberty with a headlight problem.
>>>> The drivers side Day time running light/high beam does not work.
>>>> When I turn the head light switch to the low beam setting both
drivers
>>>> and passengers head lights work. When I pull back on the turn signal
>>>> stalk to flash the high beams only the passenger side lights up.
Then,
>>>> when I switch the high beams on, the same thing. Only the passenger
>>>> side lights up.
>>>> Both head light bulbs work. So that's not the problem. All the fuses
>>>> check out as well.
>>>> I have replaced the Day time running light relay but that is also not
>>>> the problem.
>>>> Could the high beam relay be partially defective? If so, where do I
>>>> find it?
>>>> I imagine that it is in the power distribution box under the hood.
Yet
>>>> when I open it I am unsure as to which relay it is.
>>>> (As I am a disabled person, I don't have the funds to purchase a full
>>>> service manual until the end of May... So I figured I would ask here
>>>> and see if any of you guys might have some insight into this
problem.)
>>>>
>>>> Thank you
>>>>
>>>> Ry'
|
