Chuck wrote:
> Well, the all new (coils, wires, plugs) OEM ignition is in. (After small
> gouge in thumb from stubborn plastic connector, and a couple of small
> scrapes on the back of my right hand. Fired up this afternoon for the
first
> time, ran OK. Next, I've gotta cleanup the wiring and cabling and find
the
> plug wire gudes that were reomoved when the coil over system was
mounted.
> Then and only then can I put the front brace back on.
>
> The 99's coil pack mounts on the rear of the engine, with the primary
side
> cable running to the front of the engine. It's a very poor location from
the
> standpoints of access and heat buildup.
Don't you love that kind of job? I still have a few wires to finish up
myself.
My coil packs are entirely exposed, and away from high heat sources, but
it did require the removal of the wind****eld washer reservoir to bolt
them to the firewall.
Luckily, I have the alternate reservoir system for Miatas with ABS,
(located next to the left front wheel under the nose), but I have never
gotten around to installing it.
Pat
|
