by Lanny Chambers <lanny@[EMAIL PROTECTED]
>
Mar 5, 2008 at 04:41 PM
In article
<32b1adf1-f179-4cb3-93b0-1b4f5b8640f4@[EMAIL PROTECTED]
>,
earache@[EMAIL PROTECTED]
wrote:
> Lug nut socket? Where should I get one, is it just a generic socket?
Yes, one of the standard sizes (which one depends on your lugs). Get a
large X wrench instead of a socket.
Instead of jackstands, some folks rip a slot in a 2x4 so it fits over
the rocker panel seam, and use it to jack one side directly below the
outside mirror. Make sure to set the handbrake firmly.
--
Lanny Chambers
St. Louis, MO
'94C
