I've been looking into going MIG also but at this point, I wanted to master
the O/A setup I have. I've been turning out some decent beads with my
torch
but I wanted to see about practical advice regarding folks that had used
O/A
while under the car and on their backs, etc for vertical/inverted welds.
If it comes down to it, my friend had a Lincoln 175Plus in his shop that I
can likely get some time with.
Thanks and take care,
Andrew.
On 10/9/07 5:26 PM, in article u3sng351ev0ok5ri377g9tcnb5d91i32o0@[EMAIL PROTECTED]
"djdave" <djdave@[EMAIL PROTECTED]
> wrote:
> Ive used coat hangers on the top of my amc gremlin fenders when I was
> a kid. They worked well.
> Any rental shops around you could rent a mig welder from? I bought one
> from harbor freight for 250 bux and L O V E it.
>
>
> On Sun, 07 Oct 2007 10:11:19 -0400, AWN
> <anixon1@[EMAIL PROTECTED]
> wrote:
>
>> I have some exhaust work to do on an old project Nissan and I'm
wondering if
>> any of you use gas torches for this? If so, what do you best suggest
for
>> the filler? I've heard that coat hanger and bailing wire material
works
>> well but I also have some rods kicking around. Do I need to grind the
tubes
>> much??
>>
>> Thanks for any input you might have.
>> Andrew.
>
|
