On Nov 24, 10:26 am, Just another guy <spacecow...@[EMAIL PROTECTED]
> wrote:
> 333882 was used from 73 to 80 on 350s and 400s If it has the steam holes
> drilled in then its for a 400. if not its for a 350. It was also used
w/o
> steam holes on Z28 350 74-76.
>
> This page shows the location of the steam holes for a 400 head. I was
> drilling the holes for my 400 block (picture towards the bottom of the
> page):
>
> http://www.cadvision.com/blanchas/54pontiac/heads.html
>
> 462624 was used on 350 Corvettes and Camaros from 1971-85, its a high
> performance head. It was also used on some 400 truck blocks.
>
> Edelbrock performer cam would work. I would be more worried about what
rear
> end ratio you have and tranny type (overdrive, auto, manual?). If you
need
> torque than get a higher rear end ratio - 3.73 or 4.11
>
>
>
>
>
> bassfi****n...@[EMAIL PROTECTED]
wrote:
> > On Nov 23, 10:14 am, bassfi****n...@[EMAIL PROTECTED]
wrote:
> >> Ok, well im getting ready to rebuild a set of heads with springs,
> >> seals,keepers,and i am going to clean a set up real good and ****t and
> >> polish them....I have two sets, one set that is on my 350 right now
> >> but it needs valve seals cuz they are totally broke in half ....and
> >> the 2nd set came off of my blown up 350.....the first set the casting
> >> # is 462624 and the 2nd set is 4333882......what would be the better
> >> set of heads to use????i have been told that both #'s arnt a very
good
> >> head but waht do y'all think????im getting ready to run a mild cam
but
> >> what is the maximum size cam that i should use??? i have an edelbrock
> >> performer intake,edelbrock 650 carb,headers 3" back to single chamber
> >> flowmasters.....and i need torque to turn the 35's so what would give
> >> me what im looking for??? Thanks
>
> > *******sorry the 2nd is 333882
>
> --
> spacecow...@[EMAIL PROTECTED]
Hide quoted text -
>
> - Show quoted text -
ok,thanks...so i should use the 624 heads then???and i have a sm465 4
speed tranny and 4.11 gears...thanks alot i appreciate it...
|
