Re: Is there a hi-temp expanding foam on the market?

I agree with Brent!

"Brent P" <tetraethylleadREMOVETHIS@[EMAIL PROTECTED]
> wrote in message 
news:RdOdndNqR6DKK77VnZ2dnUVZ_q_inZ2d@[EMAIL PROTECTED]
> On 2008-05-09, Fred Mann <famnn@[EMAIL PROTECTED]
> wrote:
>> Hello,
>> I have a small hole in the exhaust manifold right where it attaches to 
>> the
>> engine -- actually a small piece of the gasket is missing. There's a 
>> little
>> space in there that would seem ideally suited to accept a dollop of
foam.
>> The foaming insulation at  the hardware store can only deal with temps 
>> below
>> 200 degrees. Is there anything out there with a higher temp rating?
>> (JB Weld works okay, but doesn't seem to last)
>
> Anything but replacing the gasket will be short-term.
>
>